epinkerton Posted June 8, 2020 Share Posted June 8, 2020 Hello everyone, I'm new to Unraid and have run into a weird issue I cant seem to figure out. Running on a Dell R710, I have 2x 8TB SAS drives and 4x 3TB SAS drives installed. One of the 8TB drives in my parity drive. For some unknown reason when a parity check happens the parity drive right at the end gets reports 155,540 read errors. I thought that this might be because I was using second hand drives, the place I purchased from provided two replacement 8TB drives and I swapped out the parity drive, same issue exists. I've used both replacement drives in place of the parity drive and it always reports 155,540 read errors. I'm at a loss. . . I've replaced the cables and raid card as well to troubleshoot and same results. Diagnostics attached. Any ideas would be greatly appreciated datapool-diagnostics-20200608-0650.zip Quote Link to comment
JorgeB Posted June 8, 2020 Share Posted June 8, 2020 Disk is formatted with type1 protection, if you Google that you'll find how to remove it. Quote Link to comment
epinkerton Posted June 8, 2020 Author Share Posted June 8, 2020 (edited) Thanks for the quick reply johnnie.black I've run sg_format --format --fmtpinfo=0 /dev/sdb Hopefully it does the trick! **fair warning for anyone reading this, the above command will WIPE your disk!** Edited June 8, 2020 by epinkerton 2 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.