dkersten

Any ideas on how to get the Palworld Docker to update to 1.3? I've restarted it a few times, but still says the server version is different than the client.

I recently upgraded my gaming rig from AMD to Intel and had boatloads of problems with the Windows OS finally requiring a complete reinstall. Now I am thinking about upgrading one of my two unraid servers from an older Intel i7-8700 to the AMD Ryzen 5900x I pulled from my gaming rig (moving to ddr4 ram, pci gen 4 bus, and of course the entire chipset and cpu are significatly different than the Intel setup). Am I going to run into any major issues if I just plug the USB in from the current server into the new server after transplanting the hardware? Am I better off starting fresh and transferring my license from the old install to the new one? Can I even do that, and if so what do I have to do before tearing down the old server?

Thank you so much for providing so many great Dockers. Is there any chance you will be creating one for "The Front"? They currently have both Windows and Linux versions of the dedicated server on Steam, but I can't find a docker version anywhere. At this time all the settings are added to the command line when you execute the server, so no ini or dll files to change, and even the ip address is included in the startup command. The game is a bit flaky right now, but the devs are very active and patching several times a week, and it seems to have some potential for those who like 7dtd, Rust, or Ark. Thanks!

It appears to be working after removing the gateway from eth1. Thanks!

With only the 1 gig nic enabled and plugged into my network, everything works fine. However, I also have a 10 gig nic that I use to connect directly to my main windows pc to transfer new rips to the UnRaid share. This second nic is on a totally different subnet that has no connection to the rest of the network (no DNS server, no gateway). I can enable the 10g nic and transfer files from my PC to the UnRaid share at 950+ MB/s, just like it should. But as soon as I turn on the port on the 10g nic, Unraid loses internet. From what I can tell, it is trying to use the second nic to connect to the internet, even though it is set as eth1, and the 1 gig nic that is actually connected to the internet is set to eth0. Can anyone help me figure out how to configure this to ignore the eth1 10gbe nic when it comes to downloading things from the internet? Attached is my ethernet settings page. I am running 6.8.3 and it is fairly clean (installed yesterday). Edit to add: I have searched for a solution and found multiple articles on how to use the 10g card as a passthrough for my PC but I have no desire to do that here, I just want to connect my PC to the UnRaid share through the 10gbe nic, the PC has it's own 1gb nic connected to the main network (192.168.1.*) and that configuration gives me the least issues (at least it did when my storage server was windows based and not unraid).