Hi,
I am new here and I do not have experience with Linux at all.
I build my NAS using my old Windows 10 PC and I noticed under Unraid WOL is not working.
Under Windows 10 WOL was working fine.
I did research and I found this NIC has a bug and WOL is disabled.
Is any way to enable WOL support?
Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: Symmetric Receive-only
Supports auto-negotiation: Yes
Supported FEC modes: Not reported
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: Symmetric
Advertised auto-negotiation: Yes
Advertised FEC modes: Not reported
Speed: 1000Mb/s
Duplex: Full
Auto-negotiation: on
Port: Twisted Pair
PHYAD: 0
Transceiver: internal
MDI-X: Unknown
Current message level: 0x000060e4 (24804)
link ifup rx_err tx_err hw wol
Link detected: yes
driver: alx
version: 5.15.46-Unraid
firmware-version:
expansion-rom-version:
bus-info: 0000:03:00.0
supports-statistics: yes
supports-test: no
supports-eeprom-access: no
supports-register-dump: no
supports-priv-flags: no
