Talisman2208

The problem is - I'm not crashing, I can't even boot. There's nothing to type in the console because I can't even boot it. It hangs up on this part.

I'm running an intel 12th gen 12900K As far as OS it was Stable Unraid 6.12.0. It's a GPU issue? I'm confused at what this is.

Can't seem to get past this part in the boot process it just hangs here. I tried disabling and enabling the IGPU but that had no effect on it. Don't see any posts about this code, does anyone have any suggestions? Obviously I have no logs because I've never booted to this disk. I used the official disk creation tool to make this with the latest stable drivers. Any help would be appreciated. Thanks!

I'm an idiot, that's 2.5gb bandwidth. Close the thread I'm drunk

Update.. . I realized I was running 100Mbps with a bad cable. So now I should be good but I'm still only getting ~300 MBps, am I being throttled by the user share instead of direct drive share?

Hey all, I'm struggling to understand why I am suffering from slow download speeds on my unraid server. I have a file on an NVME drive on my unraid server, and when I try to download it to another computer on the network it's like 10MB/s This is all despite the unraid server being on a 10gb nic, into a 10gb switch, which is connected to the pc i'm downloading it to through a 10gb nic, all using CAT 7. Where do I start to troubleshoot this?

Not sure what I did but I fixed it

Just replaced my cache drives with 2x NVME 970 Evo 2TB, and ONE of the drives is kicking back this error, does anone know how I can fix it? I googled it but none of the solutions have worked thus far. https://imgur.com/a/nDTkjWD

Hello! I have an old motherboard I'm swapping out and it has a Pool of 2 1TB Ssd's on Sata. The motherboard also has 1 M.2 port. My plan is to basically swap those 2 Sata Cache drives with 2 M.2 Cache drives on the new motherboard. Since I can't put Both Nvme drives in at the same time, how do I prepare my Cache so it can essentially run on 1 NVME drive until I get my other Motherboard in there and install the second one into the pool? Thanks! P.S. I can't do it after I install the new mobo because my old mobo has 10x Sata ports and my new mobo has 6x sata ports.

When you say "Unassign" does that mean unmount them (software wise)? Also - How do I see when the mover is finished?

I want to get rid of my two cache drives which are Sata SSD's, and replace them with a 2TB NVME drive, how do I do this? Sorry if this is a dumb question!