I have potential data loss after the following: 1. Last week (Wednesday/Thursday) disk 1(ST6000NM0034_Z4D3G2S20000R621P1K1) reported errors and became disabled (it had also previously reported errors, so I ordered new drives and waited for them to arrive) 2. Automatic weekly parity ran on Monday morning which stopped part way through (30-40%) with errors on parity disk 1 (I have dual parity setup) 3. On Tuesday 11/17, I turned the server off and replaced disk 1 with a new drive 4. I turned the server on, stopped the array, rebuilt (the new) disk 1 (ST6000NM005B_WX00AT5W0000C2499Z4H) and (the old) parity 1 (I know that this step was likely the primary source of the issue) 5. Rebuild finished Tuesday night, when the rebuild was done I noticed that parity 1 had millions (billions?) of errors and no disk temp (reported as "*") 6. I stopped the array to rebuild parity 1 (didn't start the rebuild) 7. Then noticed disk 1 had a warning that it was "not formatted" 8. I followed the steps to "repair the filesystem" (XFS) (from https://docs.unraid.net/unraid-os/using-unraid-to/manage-storage/file-systems/#checking-a-file-system) , a corruption was reported and I clicked "Fix corruption" (here I noticed many lines printed) 9. I started the parity rebuild of parity 1 10. Then I noticed that most of the data was missing from disk 1, so I stopped the parity build at < 1% in and turned off the server Note: I do still have the old disk 1, which had errors but I imagine most of the data is still on this old disk. Also, when I turned on the server to collect the logs and cache device 2 (ST6000NM0054_Z4D38NTD) was reported missing, so I did not start the array to check the lost+found on the new disk 1. Is it possible to recover any of the data from disk 1 (I assume this would need to be done using the old drive)? Is there a guide somewhere I can follow to do this? And where does fixing parity 1 and the missing cache drive fit into the process? I've also attached the diagnostic log.
bebop-diagnostics-20261119-1212.zip