gef0rce

Hi I had a similar issue , what I did was typed "exit" and then went to "Boot Manager" and I could not see my drive ... and I by chance selected "Misc Device" and it booted into my windows Partition. Hope it helps anyone with same issue. Regards

Hi Just update , I managed to resolve the issue. My switch had the port i linked to unraid in a bridge and I had to disable it. It works now. Regards

hi bonienl I am pinging from the VM to the default gateway which is on the same subnet so there is no routing on layer 2 switching. This is my idea , I have two network cards on my unraid system , eth0 is for my lan. And eth1 is plugged directly on my LAB switch. The link between my lab switch and unraid (eth1) is trunked and only vlan 20 is allowed from my switch side. On unraid I added vlan 20 to eth1 by using the network settings page. Unraid then created an interface called "br1.20" . I assigned br1.20 to my VM and on the switch I have an ip that belongs to vlan 20. So they are on the same vlan. When i try pinging from the PC to Switch or vice versa I cannot reach. Is there something additional that is required on unraid to make dot1q tags work?

Hi I have tried enabling dot1q vlans on the unraid system and trunked the vlans to my network switch. However when I assign a VM to the vlan I cannot ping any ip on that vlan. Has anyone been able to setup vms (eth1 , "br1.20") and assigning to vlans . Is there anything special i need to do on the unraid host apart from network config. Regards

Hi Kode Can you recommend me one you are using.

Hi All Is there a resolution to this. I am also facing the LOCK when installing AVAST after all my virtIO drivers are installed. Regards

Thank you kode54. I will read up on it.

Thanks kode54 Do you perhaps have a link i can use as reference to read up to get it to work?

Hi kode54 Thank you for the feedback. The issue I am currently facing is that I have a linux vm assigned with 16GB of memory. And when it is running it consumes that 16gb when under load and when in idle the vm resumes back to normal however in the unraid gui I still see it is holding the 16GB of memory. I know from VMWare Tools in VMWare that memory ballooning is what manages this , what is the equivalent in this case?

Hi Zero Can you share with me what command you used to install vertio drivers?

Hi Trurl Thanks for quick response. I will try that.

Hi Team I tried the upgrade from 6.2 to 6.3 an once I had to reboot I get the boot screen and then I get the following error. "LZMDA data is corrupt" -- System halted I could never do I clean upgrade using the GUI , I always had to reflash my USB drive for it to work smoothly. Why does the web upgrade not work for me?

Hi zero80472 Thanks will try, did you see any improvement any memory and cpu management after installing these drivers? Regards

Hi Team Is it possible to install like vmware has "vmware-tools" for linux guest like Ubuntu. I am unable to shutdown VM from unRAID portal. Please advise?

Hi Vizhouz Have you got this working , I am trying aswell to run VMware under KVM.