Lothar

The new fan script in the latest release 2018.10.14. Is working very well for me. No more having to adjust the settings on my hard drive fans on FANA to get them in control after reboot. Thank you for the great work.

30 sec. on temp. and 2 min. on HD. The fans were at full RPM for 15-20 min. While I was troubleshooting. I had the same thing happen on my backup server that I updated after. It may have something to do with going from 2 decimal places to one, as the settings were saved from the previous version at 2 decimals but when moved were corrected to one.

You'll have to give me a little more info. I have the exact board and it's working for me. What are your fan settings? What does the ipmifan log say? Clear the log and start and stop the fan control. You can also stop fan control and run ipmifan - - debug and post the ipmifan log. I did get it working, just moved fan control settings around it started functioning normally.

I am having issues with the latest update 20180520. The plugin no longer controls my fans all are running at full RPM. I have tried uninstalling and re-installing. This is on a Supermicro X11SSH-F. EDIT Fixed now. I had to reset all temp and fan settings.

Have you set the lower thresholds for your fans. See this post. https://forums.freenas.org/index.php?resources/how-to-change-ipmi-sensor-thresholds-using-ipmiutil.34/

Working great now, thank you for the plugin. I am going to get a SilverStone CPF04 PWM Fan Hub to run my hard drive fans off of, I have used them before and they have worked well. Supermicro only having one FANA zone header on their motherboards makes no sense.

Yes, sorry I should have listed that I do have PWM fans. I think I may be on to the cause, I was using a PWN fan splitter for my 2 hard drive fans, I just removed it and I think it is working now. Will have to test a bit more. Thank you for the quick response. I will let you know.

Thank you for the great plugin. I do have an issue with it on my Supermicro X10SLL board. It does not control my fans even though I have set fan control set to yes. I have the latest BIOS and IPMI firmware installed. It reads all of the sensors fine just doesn't control the fans. I have removed and reinstalled the plugin a few time to no avail.