hikipoklica Posted March 1, 2021 Share Posted March 1, 2021 Hey all! I bought a LogiLink PCIe NIC to add to my server since the on board one doesn't support WoL and I kinda need it badly. The card is detected in BIOS and in unRAID (has two ports, therefore identifies as eth1 and eth2 next to the on board eth0) and when I plug in the cable the lights on both the card and the switch light up to confirm gigabit connection. However, on the GUI in that case all three network interfaces are shown as "interface down". I tried with both ports and got the same result. The eth0 is working normally when plugged in. When I do ifconfig I get only eth0 (showing no connection) also when the cable is plugged into the PCIe NIC. I feel like I am getting stuck on something simple but I can't figure out what... Any ideas? Thanks a lot for the help! Cheers! Quote Link to comment
JorgeB Posted March 2, 2021 Share Posted March 2, 2021 Please post the diagnostics -> Tools -> Diagnostics Quote Link to comment
hikipoklica Posted March 3, 2021 Author Share Posted March 3, 2021 Here it is. Thanks in advance! jarvis-diagnostics-20210303-1705.zip Quote Link to comment
JorgeB Posted March 3, 2021 Share Posted March 3, 2021 If you want to use the add on NIC as the main one you need to change it to eth0 (Settings -> Network Settings -> Interface Rules), if not it's need to have an IP address set (dhcp or static) to not show port down. Quote Link to comment
hikipoklica Posted March 8, 2021 Author Share Posted March 8, 2021 Thanks a lot! I finally got around doing this and now it works. However, the wake-on-LAN still doesn't work, although I followed all the steps of the guide on the unraid wiki... I am really running out of ideas here and I desperately need it to work... Quote Link to comment
JorgeB Posted March 8, 2021 Share Posted March 8, 2021 Sorry, can't really help with that. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.