Folks, i keep seeing these same two lines in my SYSLOG.

Can someone tell me how i resolve them

 

Dec 10 02:13:20 Tower kernel: traps: Plex Media Scan[4781] general protection fault ip:1479cbff07a6 sp:1479c6cb5888 error:0 in ld-musl-x86_64.so.1[1479cbfe0000+53000]

 

Dec 10 03:40:01 Tower root: mover: array devices not mounted

(as far as i know, all my disks are mounted & working fine - flash, parity, cache, data disks)

#1 - Typical Plex issue which is harmless.  Happens all the time due to errors they make

 

#2 - Post your diagnostics

Sorry.  Here you go.

 

tower-diagnostics-20211210-2341.zip

@Squid

Could i ask you to take a quick look at my Diagnostics file ? 

Its about the "mover: array devices not mounted" lines in SYSLOG.

 

You don't have user shares enabled in Settings - Global Share Settings.  Using the server like that isn't an "issue" per se, but it is very oddball, especially since probably a lot of containers etc are going to reference /mnt/user/.... and if you're not careful and adjust every reference to instead be /mnt/diskX (or /mnt/cache) you're going to wind up in trouble.

2 minutes ago, Squid said:

don't have user shares enabled in Settings - Global Share Settings.

This was an issue in a 6.10rc but shouldn't have happened in 6.9.2. You've been a forum member longer than me. Have you never had user shares enabled all this time?

@Squid @trurl

Guys, i have never used user shares on my UnRaid system.

Since 2009 i have used a disk share model exclusively.

I like having an exact location for my music, video & data.

I’m not a power user. 

I run Plex & a few utilities.

It works for me, and i’m happy.

 

Is this ‘mover - array devices not mounted’ thing related to user shares

 

Yes, except that if I set up my system as 6.9.2 or 6.10 the scheduled time mover runs doesn't log that error (but will display it if I simply run mover at the command prompt)