Would like a second opinion on the health of this drive and whether or not I should rebuild it onto itself.

 

Currently doing a read check on the array after an unplanned power outage. The read check stopped on it's own at about 50% and that's when I noticed the disk was disabled. I resumed the read check and it's now at about 58%.

 

Attached is the short test log. The extended test seemed to still be at 10% after 30-60mins, so I didn't let it complete or run it again (yet).
Also attached diagnostics that logged when the parity check errors started occuring.

 

Thanks muchly.

ryzen-smart-20220201-1447.zip

ryzen-diagnostics-20220201-1514.zip

ryzen-smart-20220201-2221.zip

Edited February 2, 20224 yr by tlrmcknz
Added extended test log

Disable disk spin down and run the extended test.

40 minutes ago, JorgeB said:

Disable disk spin down and run the extended test.

Thanks, doing that now.

Would this the expected amount of time for it to finish?

Extended self-test routine recommended polling time: 957 minutes.

Edited February 1, 20224 yr by tlrmcknz

2 hours ago, tlrmcknz said:

Thanks, doing that now.

Would this the expected amount of time for it to finish?

Extended self-test routine recommended polling time: 957 minutes.

I normally reckon on something like 1-2 hours per TB.

Added the extended self test log to the first post just for reference, but it failed at 40%. Guess it's time to replace. Are there any steps to take to validate emulated data first? Or what's there now is all there is, and just need to disk swap and rebuild?

Just replace and rebuild. 

10 hours ago, tlrmcknz said:

Or what's there now is all there is, and just need to disk swap and rebuild?

Whatever is currently showing on the emulated disk is what you will end up with on the physical disk after a rebuild.