sirelewop14 Posted July 6, 2022 Share Posted July 6, 2022 Hello! I have been putting off updating to 6.10.3 out of sheer laziness and finally decided to pull the trigger today. I updated from within the GUI using the OS Update function in the Tools section. Update installed, reboot and I hit a Kernel Panic before I see USB devices or disks (sda,sdb etc) start loading. Unfortunately the content on the screen is moving too fast for me to tell what step the kernel panic is happening on. I wiped my USB drive and performed a clean install using the USB Creator tool of 6.10.3 just to rule out some issue with my config. I tried booting in Safe Mode, No GUI, Yes GUI, etc. Same issue no matter what. I restored a backup of 6.9.2 and the server is back up and running properly. What can I do to troubleshoot the failed boot on 6.10.3? Hardware specs: Model: Custom M/B: Supermicro X9DR3-F Version 0123456789 - s/n: 0123456789 BIOS: American Megatrends Inc. Version 3.3. Dated: 07/12/2018 CPU: Intel® Xeon® CPU E5-2630L 0 @ 2.00GHz HVM: Enabled IOMMU: Enabled Cache: 384 KiB, 1536 KiB, 15 MB, 384 KiB, 1536 KiB, 15 MB Memory: 128 GiB DDR3 Multi-bit ECC (max. installable capacity 192 GiB) Network: bond0: fault-tolerance (active-backup), mtu 1500 eth0: 1000 Mbps, full duplex, mtu 1500 eth1: 1000 Mbps, full duplex, mtu 1500 Kernel: Linux 5.10.28-Unraid x86_64 Quote Link to comment
sirelewop14 Posted July 6, 2022 Author Share Posted July 6, 2022 Diagnostics bundle from after restore of 6.9.2 in case it helps reginald-diagnostics-20220706-1655.zip Quote Link to comment
JorgeB Posted July 7, 2022 Share Posted July 7, 2022 I would try a clean install with a different USB just to see if it boots, also look for a BIOS update and/or try both CSM and UEFI boot. Quote Link to comment
sirelewop14 Posted October 5, 2022 Author Share Posted October 5, 2022 Overdue update - today I created a USB and was able to do a clean install boot to 6.11.0 I wiped the drive, tried 6.10.3 and had the same issue. I just upgraded from 6.9.2 -> 6.11.0 and that seems to have gone fine. I'm not sure what about my hardware is unhappy with 6.10.X though. 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.