DaFr0n Posted September 30, 2022 Share Posted September 30, 2022 I recently had a power cut and parity rebuild started (Write corrections enabled) after completing it states there is 4 errors, what's the best way to verify or check what the errors are? I have recently switched from a Marvel controller to a flashed Dell Perc H310 due to disks always disconnecting but never had a parity issue? unraid-diagnostics-20220930-1834.zip Quote Link to comment
JorgeB Posted September 30, 2022 Share Posted September 30, 2022 1 minute ago, DaFr0n said: what's the best way to verify or check what the errors are? There's really no way, parity was out of sync, now it's in sync, unless you were writing data to the array at the time the power failed everything should fine, and with just 4 sync errors it could not be writing much. Quote Link to comment
DaFr0n Posted September 30, 2022 Author Share Posted September 30, 2022 Would you run another parity and see what the output is? Cheers for the advise Quote Link to comment
JorgeB Posted September 30, 2022 Share Posted September 30, 2022 You can, but it should be 0, unless you typically get sync errors, if you don't I would just wait for the next scheduled check, assuming you do them regularly, like once a month. Quote Link to comment
DaFr0n Posted September 30, 2022 Author Share Posted September 30, 2022 Yes its scheduled for once a week, not sure if this is to much? No its the first time i have seen a sync error Quote Link to comment
JorgeB Posted September 30, 2022 Share Posted September 30, 2022 We usually recommend once a month, it's enough. Quote Link to comment
DaFr0n Posted September 30, 2022 Author Share Posted September 30, 2022 I will get it changed, thanks for the help 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.