Missing data drives after adding a new M2 SSD

[menseph]

Hi,

newbie here so wantering what happened. Searched a bit but could not find a solution.

I added a new m2 ssd in a free slot I had in the system. after reboot I can see both m2 ssds but none of the data HDDs

 

looked in Bios and there I see everything.

even tried a tools -> new_config

 

Attached a diagnostics. any help would be appreciated.

if I should have created the topic somewhere else please point me in the right section.

 

Thank you,

Alex

 

homenas-diagnostics-20231129-2039.zip

[JorgeB]

Are you sure you didn't touch a power cable/splitter, assuming there are disks on the onboard SATA nothing is being detected:

 

Nov 29 20:17:43 HomeNas kernel: ata7: SATA link down (SStatus 0 SControl 300)
Nov 29 20:17:43 HomeNas kernel: ata5: SATA link down (SStatus 0 SControl 300)
Nov 29 20:17:43 HomeNas kernel: ata6: SATA link down (SStatus 0 SControl 300)
Nov 29 20:17:43 HomeNas kernel: ata2: SATA link down (SStatus 0 SControl 300)
Nov 29 20:17:43 HomeNas kernel: ata1: SATA link down (SStatus 0 SControl 300)

 

[menseph]

pretty sure. oppened the case again and checked after initial reboot. And also since they appear in the Bios with capacity and vendor I doubt it.

But I will check again a bit later if no other ideas come through.

[itimpi]

You might also want to check your motherboard manual in case adding the m2 ssd disables something else.

[menseph]

found the issue, some id's on devices got moved around and a sata controller was vfio bound for some reason.

unbounded it from devices and then rebooted to take effect