Replaced PSU and all cables, parity still disabled

[AlbertoGa]

Continuation from this:

I have replaced my PSU for one with 850W, replaced all cables for the ones that come with the PSU. Just in case, I used 2 separate cable ribbons so I don't have more than 2-3 drives in a single SATA power cable.

 

Hard drives are still plugged directly into the MOBO, no HBA.

 

Started the NAS again but main panel looks similar, parity device is disabled.

 

I'll post the new diagnostics here.

 

How should I proceed?

 

 

nas-diagnostics-20240919-1334.zip

[JorgeB]

Do you mean it's still disabled after replacing the cables or you replaced the cables and it got disabled again?

[AlbertoGa]

It's still disabled

 

The only thing I did since that post was to shutdown the server, replace PSU and cables and I started it back up again today. I didn't do anything else.

Edited 9 hours ago by AlbertoGa

[JorgeB]

2 hours ago, AlbertoGa said:

It's still disabled

That is expected, once a disk gets disabled it needs to be rebuilt.

 

https://docs.unraid.net/unraid-os/manual/storage-management#rebuilding-a-drive-onto-itself

[AlbertoGa]

In maintenance mode the parity drive shows this:

 

Short self test results in no errors. Is it safe to use to rebuild or do I need to swap it?

[JorgeB]

Short test is not a great indication, you should always run the extended test, but based on the SMART report the disk should be OK.

[AlbertoGa]

1 minute ago, JorgeB said:

Short test is not a great indication, you should always run the extended test, but based on the SMART report the disk should be OK.

 

Thank you! I'll rebuild the array and post how it goes!