Hey guys.  I was running 5.0rc15a I believe and I had a drive fail.  I popped in a new drive and the array rebuilt.  Now when I try to write to certain shares I get read only access errors.  I upgraded to 5.0 at that time to see if I could resolve that issue.  the mover is also not working.  I ran the permission reset script and that still didn't work.  From what I can tell by the logs disk 20, which was the one replaced, is still not working correctly.  It is still green though on the main page.  Any suggestions on how I can resolve this?  Any help would be greatly appreciated. 

 

Thanks,

 

Bill

unraid_log.txt

Read only access suggests file system corruption has occurred.    The solution is to put the array into Maintenance mode and run reiserfsck check against any of the problem drives.

I did the reiserfsck suggested above on disk 20 and I then used the --rebuild-tree command as the program suggested.  It found 7 corruptions and fixed them.  When I started the array again I had the same problem.  I am going to replace disk 20 again and see if I just had another faulty drive.  Any other suggestions if the new drive does the same thing?  I really would like to get this working. 

 

Thanks,

 

Bill

Attach the entire syslog.

I have actually fixed this issue.  Turns out the 2nd drive was bad.  Now I am having an issue with plex, but I will start a new post for that.

 

Thanks for all the help.

 

Bill