January 15, 20179 yr So is it better to use the most fill with drives of diffeerent size? No. (I don't) But assume this on the data drives 4tb 3tb 1tb Using high water, the system will fill disk1 until it has 2tb free Then it will fill disk2 until it has 2tb free Then it will fill disk1 until it has 1tb free Then it will fill disk2 until it has 1tb free then it will fill disk1 until it has 500gb free Then it will fill disk 2 until it has 500gb free Then it will fill disk 3 until it has 500gb free. High water is all based upon the largest data drive in the system.
January 15, 20179 yr Author Ok so my issue is: 6tb free 1.77 TB 2tb free 768 MB 2tb free 14.7 GB 2tb free 84.1 GB I was concerned the 768 MB free was causing the issues on the drive. I'm not sure if it was issue before added 6tb or on going one due to setup
January 15, 20179 yr Ok so my issue is: 6tb free 1.77 TB 2tb free 768 MB 2tb free 14.7 GB 2tb free 84.1 GB I was concerned the 768 MB free was causing the issues on the drive. I'm not sure if it was issue before added 6tb or on going one due to setup Highwater will continually write to disk 1 (unless split settings forces it onto another drive) until disk 1 has 46.875Gig free But since everything is apparently going to disk2, its going to be a split level issue. (It could also be a included / excluded drive(s) in the share / global share settings)
January 19, 20179 yr Author Ok i fixed every other problem but the freezes are still on going. I posted on emby forum and received no replies. If I leave the emby docker on I'm unable to access the web UI or any docker page and tower stop showing up on my network. I'm unsure how to pull the log files while it's in this state. And I'm sure hard rebooting damaging my drives. Any insight how to resolve this would be greatly appreciated.
January 19, 20179 yr Community Expert Ok i fixed every other problem but the freezes are still on going. I posted on emby forum and received no replies. If I leave the emby docker on I'm unable to access the web UI or any docker page and tower stop showing up on my network. I'm unsure how to pull the log files while it's in this state. And I'm sure hard rebooting damaging my drives. Any insight how to resolve this would be greatly appreciated. Did you ever show us your docker run command?
January 19, 20179 yr Author I'll attach the previous log i posted and the new one till emby freezes. I don't know how to get the log after crash and reboot. I did notice a mono runtime error but didn't understand what meant after googling it embylog.txt emby2.txt
Archived
This topic is now archived and is closed to further replies.