MomSpaghetti Posted April 21, 2020 Share Posted April 21, 2020 Hello, I just upgraded my server from a 8350x to a 3900x build, before I had a 10gb mellanox card set up as eth0 and eth1 as a backup Ethernet port. After the upgrade i noticed that the link status of the card was not lighting up. So I took it out of the server and flashed the newest firmware on it, then put it back in the server. After this i noticed that the link and activity lights were working however Unraid says the connection is down. Logging into my gateway it shows me that the mellanox card is connected, however I can not ping the server when only connected via the mellanox card. In order to connect to the server I need to plug a Ethernet cable in the back of the motherboard. How can I get unraid to recognize the mellanox card? Thank you for your help in advance, bellow I have attached a recent diagnostic file. lilith-diagnostics-20200421-1636.zip Quote Link to comment
JorgeB Posted April 21, 2020 Share Posted April 21, 2020 eth0 is currently a Realtek NIC, Mellanox is eth1, change it to eth0 on Settings -> Network Settings -> Interface Rules (reboot required after). If that doesn't work rename/delete network.cfg and network-rules.cfg (both on boot/config), reboot and reconfigure your LAN, initially you can boot with GUI mode if needed. Quote Link to comment
MomSpaghetti Posted April 22, 2020 Author Share Posted April 22, 2020 Okay, thank you for your reply Under the interface rules the only 2 interfaces shown are eth0 and eth2 for some reason If I delete the network.cfg and network-rules.cfg and reboot will unraid rebuild the files to the default config? Do I need to edit anything in the cfg files or just delete them? Thanks again Quote Link to comment
JorgeB Posted April 23, 2020 Share Posted April 23, 2020 10 hours ago, MomSpaghetti said: will unraid rebuild the files to the default config? yes 10 hours ago, MomSpaghetti said: or just delete them? On 4/22/2020 at 12:03 AM, johnnie.black said: rename/delete Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.