poiy Posted June 10, 2020 Share Posted June 10, 2020 Hi Community I cant add a new HDD to my Array. I use a Hotswap Case 16 Bay with two backplanes (at the moment I just want to use the upper backplane). The Raid Controller I use is the Fujitsu D2607 in IT-Mode. I use both SFF-Ports of the Raid Controller to the first backplane (2x4) but only the upper row got regognized. I cant add it to the array and in Tools -> System_Devices it doesnt pop up. It's a WD 8 TB EZAZ- 11TA... not TBA. First i thought it is because of 3.3V. Than i covered the 3 Pin but the drives spins up fine even without taping it. Than put it in the first row and it got regognized with and without 3.3V So why cant I see drives in the second row of the backplane? The SFF8087 Cables are both fine. The drives got power from an 350W PSU with 3 Molex cable from the PSU. (one is an SATA to Molex adapter). Someone got an idea? Quote Link to comment
JorgeB Posted June 10, 2020 Share Posted June 10, 2020 Have you swapped the ports on the HBA? That model is known to only have a working port when incorrectly flashed to IT mode. Quote Link to comment
poiy Posted June 11, 2020 Author Share Posted June 11, 2020 How do i check if it s incorrectly flashed? Quote Link to comment
JorgeB Posted June 11, 2020 Share Posted June 11, 2020 By swapping the cables on the HBA, if the problem follows the port it's not correctly flashed. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.