Mkultra

Members
  • Content Count

    14
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Mkultra

  • Rank
    Newbie
  1. Thanks for the help guys, Im swapping out a motherboard/cpu on this machine next week so i may just wait until thats done! Maybe rc3 will be ready to put through its paces by then anyway
  2. this is what i get on 6.8 smartctl 7.1 2019-12-30 r5022 [x86_64-linux-4.19.107-Unraid] (local build) Copyright (C) 2002-19, Bruce Allen, Christian Franke, www.smartmontools.org === START OF READ SMART DATA SECTION === SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x002f 100 100 000 Pre-fail Always - 0 5 Reallocate_NAND_Blk_Cnt 0x0032 100 100 010 Old_age
  3. yes it looks like that on 6.8 however on 6.9 ther terminal gave me short 3 line response telling me Smart status is enabled
  4. Yes im am getting temps on 6.8. I have restored back to 6.8 now and unfortunately didnt note it down however it was a short 3 line response telling me my smart is enabled... however as i said not what i expected. This gui also showed this in disk settings: SMART support:Available - device has SMART capability. SMART support:Disabled
  5. SATA controller: Intel Corporation 7 Series/C210 Series Chipset Family 6-port SATA Controller [AHCI mode] (rev 04)
  6. Unfortunately im not at home at the moment. Im running openvpn though, is there any way of checking this on the unraid GUI?
  7. If it helps my four array hdd's are also plugged directly into the sata ports on the motherboard. I have no LSI expansion card etc installed on this machine.
  8. Sata SSD connected straight to the motherboard
  9. IN RC1 i couldnt see the hdd temps no matter what i tried... in RC2 i can see array temps if i spin down then spin up the drives. As far as the cache and flash go nothing i tried made the temps show. Could not get smart enabled on the cache.
  10. Tried RC1 and couldnt get any hdd temps.. Tried RC2, now getting hdd temps when spinning up/down the drives on array but can get no temp on either the cache or flash. Cannot get SMART enabled on cache either. restoring to 6.8 for now.
  11. I have the same problem! anyone figured out a way to fix this? I've tried smartctl '-A /dev/sdX' and i get a message back telling me smart status is enabled.. however when i go into the hdd settings it tells me this: SMART support:Available - device has SMART capability. SMART support:Disabled Very confused!
  12. Hi Guys First post here and i wish it could be more positive. Literally trawled these forums for days for help. I've been having extremly slow read and write speeds on my array since moving to unraid(Often below 1MBps). I've run a freenas server in the past but im completely lost as to what my problem is, Cant see what im missing. Im running a 2TB WD Red as parity as well as a identical drive and a 1TB WD black in the array, I also have an ocz SSD which i am using as cache. The server is hooked up directly to the router which supports 1000MB transfer speed