Billy Pilgrim

Thank you! You are a legend.

Sorry, I used the wrong terminology, but that's what I meant. The check worked. It is up and running. Now to see if it will run a parity in a reasonable amount of time.

Ok. It took a couple of days but I was finally able to get to it. I'm not sure why but only one of my drives was running through the SATA controller. Now they are all running through the SATA controller. The drive is no longer "Missing", but it does show "Unmountable: Unsupported or no file system" again. I need to first rebuild the file system, correct? Here is the log I collected after moving the other two drives to the SATA Controller. croweflix-diagnostics-20241020-1306.zip

A couple of weeks ago I shut down to clean the server. When I turned it back on I had an issue with Disk 2. The message was: "Unmountable : No file system." I collected a log then, which I can upload if needed. I ended up finding in the documentation a way to rebuild the file system and it worked. Everything was functioning normally. A couple of days ago I was transferring a file to the array and it failed. When I pulled up the Unraid UI, it now shows: "Device is disabled, contents emulated." I am going to replace all my SATA cables, check my SATA controller is seated, etc. I am hoping that someone can provide some insight into why this may be happening, and what I might do to fix it. Also, when I tried to run a parity check (before the drive error messages) it said it will take 200 days and the speed is like 50 kbps. Any help is greatly appreciated. Thank you in advance. P.S. - The diagnostics I attached are the most recent, but I have the one from when it had the "Unmountable : No file system." issue. croweflix-diagnostics-20241017-1212.zip

Did you ever find a solution to this?