essessell

This has also happened to me .. removing and reinstalling cache directories seemingly has fixed the issue for me thus far

bump

on my system running 6.8.0 system stats disk usage page looks like this. my monitor is an NEC 2k. Is it my monitor or is there a way to scale up the graphics?

OK .. I believe I have figured it out. My linux machine was set to dhcp and somehow it assigned the network ip out of the ip range of the unraid docker. So ... I assigned a static ip on the linux machine and presto... i have UI again .. I suppose if anyone else has exhausted all other avenues .. check your machines ip address. lesson learned. Thanks binhex for taking the time to troubleshoot

I have it running on one machine just to test it out. but when I use another machine it still doesn't work even when I have PIA turned off. I'm not using pfsense. I do have ubiquiti USG and I've looked for anomalies there but didn't see anything that could be blocking

steve@ubuntu-18:~$ sudo ufw status verbose [sudo] password for steve: Status: inactive I think ubuntu allows all outbound traffic by default Is there anywhere else I should look that might be keeping the UI from loading

well almost figured it out.... It loads fine on my windows machine but still won't load the webUI on my Ubuntu machine where I have the PIA client installed. It actually did load for a minute then when I tested it again it wouldn't load. I'm using Ubuntu 18.04 OK I tried on another linux machine and the webUI won't load there either... What could be the matter?

my LAN is actually configured as 192.168.254.0 I've tried 192.168.254.0/24 and still no go. I did read Q3 and then googled around and from what I can gather it should work. I am able to run pia from linux just fine. I've also deleted docker.img and started over with same results. OK I figured it out .. It's nothing to do with my configuration or the docker .. I have two LAN interfaces on my server and they were both connected however it was a hardware configuration that was screwing things up so I unplugged one LAN cable and now I am able to get to the webUI. . Thanks for confirming my .log was ok. That really led me to investigate what else could be wrong. Again great docker.. thanks for the work.

Well, I have exhausted my brain trying to get the web UI to work. It runs fine when VPN_ENABLED is set to no. Can you have a look at my supervisord.log? supervisord.log