lanky8804

@trurl Ah ok, so I presume with this information monthly if not greater would be acceptable for parity then moving forward. Full Diagnostic attached. unraid-diagnostics-20210329-1858.zip

So I have the current scenario and before I go messing with anything was hoping for some advice please. Last parity check got stuck at 3.4% after 16hours due to a disk with errors (can hear it clicking away). Disk still green and no failure notice as yet. As a result I had to cancel the latest parity check (28/3/21) however I run parity checks weekly and the one before this was successful (21/3/21) What is the best way to replace this disk? If you cancel a parity check does it revert to the last fully complete one? Many thanks

This is the extended SMART test. WDC_WD4000F9YZ-09N20L0_WD-WMC1F1432192-20210117-1244.txt

Morning Just had a disk throw up some errors, however when added and pre-cleared was all ok. Parity check completed last night also says no errors. Don't really understand how to read/what to look for on the disk diag and what has caused this issue. Any support greatly appriciated. Thanks unraid-diagnostics-20210117-0942.zip

Hi, Yes i have switched from bridge to host, i updated the docker. Should i try installing from scratch?? I know the muxes and have the .m3u file which i can open to view the individual streams. How do i add?? Thanks

Anyone got an idiots guide to setting up IPTV on TVHeadend?? Am struggling to get IPTV working and am fairly tech savy.

Thank you for the replys, so just to confirm i need host mode? It did install once i set the recording dir, however now when i try to add IPTV channels when it scans them it come up with FAIL. is this because i didn't choose host mode or something else?

Can get this installed, sure it is something basic, can anyone help?? Just want to use it for IPTV

+1 from me also