onureemus

For me the problem seemed to be ZFS so i changed over to XFS cause i could. So i booted up my server (haven't built up the ' server ' room) so i run it as i need to dump large amounts of new data on it and i was running ZFS on the older version of unraid and after updating i see random CPU cores getting pinned, memory was fine (running two E5 2603 V4 Xeons and 32gb of 2400mhz ECC memory on each CPU)

If i use the either "steam lan cache" or "steam cache bundle" they seem not to work with unraid 6.8.2 (prob im doing something wrong), but they did work with unraid 6.7.1 (@100mbps) and as i updated to 6.8.2 i did a fresh install formatted all drives (cause im still in the setup stage) and opted to use the 10gbps connection only, SMB works fine from my pc's ssd to the array about 550mb/s and thats cause the ssd's speed is 550mb/s read also i know the box has internet connection cause i installed the docker containers i did tried lot of settings and ip's and docker container network modes, also i really dont want to go back to 6.7.1 cause the smb was a bit wonky for me there and cause the docker speed was as fast as my connection so no win there Model: Custom M/B: ASUSTeK COMPUTER INC. Z10PA-D8 Series Version Rev 1.xx BIOS: American Megatrends Inc. Version 3801. Dated: 08/23/2019 CPU: Intel® Xeon® CPU E5-2603 v4 @ 1.70GHz (2 of them) HVM: Enabled IOMMU: Enabled Cache: 384 KiB, 1536 KiB, 15360 KiB, 384 KiB, 1536 KiB, 15360 KiB Memory: 64 GiB DDR4 Multi-bit ECC (32gb per cpu) Network: bond0: fault-tolerance (active-backup), mtu 1500 eth0: interface down eth1: 10000 Mbps, full duplex, mtu 1500 Kernel: Linux 4.19.98-Unraid x86_64 OpenSSL: 1.1.1d

Im probably doing something wrong, but if i use this docker container with unraid version 6.8.2 it just does not work nor does the steam cache bundle, but if i use it with 6.7.1 it works but with very low lan speed (100Mbps max) (also then smb works with max 1Gbps speed) what makes it useless cause my isp provides me with 100/20 connection and thats fatser then what i get from my unraid box limited by something software cause i have a 10Gbps fiber connection to the box anyone have any ideas ? ive tryied different network modes and different settings on all network adapters M/B: ASUSTeK COMPUTER INC. Z10PA-D8 Series Version Rev 1.xx BIOS: American Megatrends Inc. Version 3801. Dated: 08/23/2019 CPU: Intel® Xeon® CPU E5-2603 v4 @ 1.70GHz (two of them) HVM: Enabled IOMMU: Enabled Cache: 384 KiB, 1536 KiB, 15360 KiB, 384 KiB, 1536 KiB, 15360 KiB Memory: 64 GiB DDR4 Multi-bit ECC (32gb each) Network: bond0: fault-tolerance (active-backup), mtu 1500 eth0: interface down (intel i210 x2 one disabled in bios) eth1: 10000 Mbps, full duplex, mtu 1500 (mellanox connect x4 if i remember right) Kernel: Linux 4.19.98-Unraid x86_64 OpenSSL: 1.1.1d