[SOLVED] 1Gbe internet w/ separate 10g network (Pulling Hair out)

[skippy4hammypc]

So about a week ago I installed a 10g card into my server, got it up and running fine and dandy. however now that I have rebooted my server it can no longer communicate with the internet on the 1gbe (eth0) and instead is trying to use my new 10g (eth4). have tried everything that has come to mind when it come to this, alas I have next to no experience with Linux and configuring routes. my last idea if this doesn't work is to trash my new 10g network😭. I can still communicate with the server over both networks, unraid just cant seem to find WAN

 

My setup is as follows

eth0 (1gbe) [192.168.1.22/24] <-> (dumb) Switch <-> (OP PfSense) Router

eth4 (10g) [10.10..10.2/24]<-> mikrotik crs309-1g-8s+in <-> Lan Computers (no access to WAN)

jarvlos-diagnostics-20210414-1245.zip

[JorgeB]

Try leaving the gateway blank on eth4.

[skippy4hammypc]

Will Try. I just set the port down and rebooted as a last dich

[skippy4hammypc]

4 minutes ago, JorgeB said:

Try leaving the gateway blank on eth4.

you know that feeling when you actually stop and think about it and go "F@#K it was that simple" 

 

left field blank and all is working now