DivideBy0 Posted September 8, 2021 Share Posted September 8, 2021 (edited) Well, my parity drive in my second UnRaid system is dead / kaput. My setup had only one parity drive. It was a 10TB drive and I plan to replace it with 8 TB as I can't buy another 10TB. What is the process? I read that replacing the 10 with a 8 is not possible, from bigger parity drive to smaller drive? My biggest data drive in the array is also an 8TB if it matters. Even with a new re-config and preserving the data won't work? There is gotta be a way right? What are the exact steps? Edited September 8, 2021 by johnwhicker Quote Link to comment
JonathanM Posted September 9, 2021 Share Posted September 9, 2021 The rule is no data drive can be larger than parity. An 8TB drive will work just fine since you don't have any data drives larger than that. It's true you can't ever rebuild a data drive to a smaller one, but that doesn't apply here. Just remove the failed drive, assign the 8TB to the parity slot, and start the array to build parity. 1 Quote Link to comment
DivideBy0 Posted September 9, 2021 Author Share Posted September 9, 2021 3 hours ago, JonathanM said: The rule is no data drive can be larger than parity. An 8TB drive will work just fine since you don't have any data drives larger than that. It's true you can't ever rebuild a data drive to a smaller one, but that doesn't apply here. Just remove the failed drive, assign the 8TB to the parity slot, and start the array to build parity. Thank you Sir and I will proceed. Sounds pretty straight forward Quote Link to comment
DivideBy0 Posted September 11, 2021 Author Share Posted September 11, 2021 On 9/8/2021 at 8:27 PM, JonathanM said: The rule is no data drive can be larger than parity. An 8TB drive will work just fine since you don't have any data drives larger than that. It's true you can't ever rebuild a data drive to a smaller one, but that doesn't apply here. Just remove the failed drive, assign the 8TB to the parity slot, and start the array to build parity. Should I do a parity check after re-build is done, just in case? Quote Link to comment
JonathanM Posted September 11, 2021 Share Posted September 11, 2021 18 minutes ago, johnwhicker said: Should I do a parity check after re-build is done, just in case? Yes. After a data drive rebuild, you should do a non-correcting check, after a parity drive build, a correcting check is prudent. As always, anything other than zero errors must be dealt with appropriately. Quote Link to comment
DivideBy0 Posted September 11, 2021 Author Share Posted September 11, 2021 20 minutes ago, JonathanM said: Yes. After a data drive rebuild, you should do a non-correcting check, after a parity drive build, a correcting check is prudent. As always, anything other than zero errors must be dealt with appropriately. Copy that Sir and thank you. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.