Wibbling Posted December 4, 2021 Share Posted December 4, 2021 Hello all, I've a Gen8 Microserver with 2 built in Broadcom NICs. broadcom1 (the first port) is currently eth0, broadcom2 is currently eth1. I've added a Mellanox Connect X 3. This is currently eth2. The current assignment is: broadcom1 eth0 broadcom2 eth1 mellanox eth2 While this works I would like to set the Mellanox as eth0. When I try to re-arrange the eth assignments on the settings page like this: mellanox eth0 broadcom1 eth1 broadcom2 eth2 However, the settings don't change with the reconfiguration. For example: IP for eth2 (the Mellanox) is set to 1.18 The Mellanox interface is set to eth0. The Mellanox card adopts the IP of eth0 It does not retain the IP of eth2, 1.18. The setting does not 'move' with the adaptor change. This caused me a few probs, the biggest one chopping me out of the UI. I think I'm asking: Should the config be re-assigned automatically? OR Do I need to reconfigure the interface IP, description, frame size prior to rearranging the interface eth assignments? As an intellectual aside, are these web UI config settings expected to be reflected in the ifconfig command? I'm a bit nervous as last time I rearranged the interface assignments as mentioned I couldn't get in to the UI. All advice most welcome. I'm sure I'm doing something wrong, I'm just not sure what! Thank you Quote Link to comment
trurl Posted December 4, 2021 Share Posted December 4, 2021 Attach Diagnostics to your NEXT post in this thread Quote Link to comment
Wibbling Posted December 4, 2021 Author Share Posted December 4, 2021 Hello,apologies, I didn't realise they would be needed. I have attached as requested: gen8-diagnostics-20211204-1444.zip Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.