fireplex Posted November 3, 2022 Share Posted November 3, 2022 I have removed 2 data disks from my system by following https://wiki.unraid.net/Manual/Storage_Management#Removing_data_disk.28s.29 That all went well, I started the array but the GUI does not look correct and seems to believe the array is not started yet it does seem to be rebuilding parity as the % is changing and my dockers are running? What should I do, leave it, or reboot (but won't that cancel the parity sync?) ? Tried clearing browser cache, different browser etc Thanks for any help!! Quote Link to comment
JorgeB Posted November 3, 2022 Share Posted November 3, 2022 If you are using Firefox try a different browser and/or clear cache. Quote Link to comment
fireplex Posted November 3, 2022 Author Share Posted November 3, 2022 Yes, I normally use Firefox but as per my post I cleared cache and tried Edge, same issue. Am I safe to leave it like this, or should I reboot? Quote Link to comment
Solution JorgeB Posted November 3, 2022 Solution Share Posted November 3, 2022 You can reboot, parity sync will start over. Quote Link to comment
fireplex Posted November 3, 2022 Author Share Posted November 3, 2022 Ok great, thanks. Quote Link to comment
fireplex Posted November 3, 2022 Author Share Posted November 3, 2022 Thanks for the help, did a reboot, came up stopped, did a start and all looks good with a new parity sync beginning 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.