YopYorn Posted November 23, 2022 Share Posted November 23, 2022 Upgrading from 6.9 to 6.11.5 and stuck in a boot loop now. I am able to boot into the GUI safe mode meaning it's most likely a plugin issue from what I've read, however, I have deleted all .plg files from /boot/config/plugins and am still unable to boot normally. Any suggestions would be appreciated. tower-diagnostics-20221123-1216.zip Quote Link to comment
JorgeB Posted November 23, 2022 Share Posted November 23, 2022 I would start by creating a new stock v6.11.5 install on a different flash drive, no key needed, just to confirm it boots in normal mode and it's some config issue. Quote Link to comment
YopYorn Posted November 23, 2022 Author Share Posted November 23, 2022 It still loops even with the fresh install with a different usb. I guess I'll go up one release at a time until it happens again. Glad I took a backup before upgrading. Quote Link to comment
YopYorn Posted November 23, 2022 Author Share Posted November 23, 2022 Looks like the furthest I can get is 6.11.1. Anything past that and I get the same boot loop issue. I tested this on a different flash drive using the manual upgrade method. This drive had no config on it. Quote Link to comment
JorgeB Posted November 24, 2022 Share Posted November 24, 2022 Can you see where in the boot process it reboots? Also safe boot still works correct? Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.