krackato Posted July 30, 2012 Share Posted July 30, 2012 So I got a C-Clamp and was able to bend all the tabs down in my Antect 1200 case. I replaced the fans in my Norco SS-500's with the Coolink fans that were suggested here. So far so good. I even got 3 of the Norco's installed and screwed in. But the last one, the one that goes at the top doesn't seem to line up correctly so that I can actually screw it into the case. Top of my system - http://i.imgur.com/CCXEk.jpg Notice the holes not lining up here - http://i.imgur.com/P7SkH.jpg This is really strange because the other ones went in fine. Is there anything I can do? Should I buy a different case? I'm not in love with the Antect 1200 anymore, if I could go back, I'd but a case that was easier to work with (if there was a case out there that was easier to work with). Any suggestions are appreciated. I know I'll get this system working, just have to keep plugging away at it. Quote Link to comment
jowi Posted July 30, 2012 Share Posted July 30, 2012 Try mounting them all upside down in regard to how they are mounted now... i had the same problem with the SS400. Quote Link to comment
marcusone Posted July 30, 2012 Share Posted July 30, 2012 Use something to lift the last one up a bit (a knife?) It should be able to "jimmy" into place. Sent from my SGH-I727R using Tapatalk 2 Quote Link to comment
wirenut Posted July 31, 2012 Share Posted July 31, 2012 Try mounting them all upside down in regard to how they are mounted now... i had the same problem with the SS400. This is what I did and it worked just fine. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.