ashman70 Posted January 14, 2016 Share Posted January 14, 2016 I just noticed that when I go into the properties of a disk there is a section that says ' smart controller type' and in the drop down are several options such as ATA, SCSI 3Ware, Areca etc. Then there are three toggles where it says 'port identifier' (select as appropriate) If I have a bunch of my disks connected to an Areca raid controller (in JBOD of course) would it add anything to make this selection for all of them? Under port identifier do I just put the port number the disk is attached to? Which of the three port identifiers do I use? Link to comment
bonienl Posted January 14, 2016 Share Posted January 14, 2016 You need to do some investigation yourself. Have a look at this topic. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.