March 8, 20179 yr Folks, I have a Samsung PM851 SAMSUNG_MZNTE256HMHP which reports "Airflow temp" under SMART attribute 190, rather than the normal attribute 194 that's used on my HDDs. Is it possible to get some way of changing which attribute is used to report temp? Thanks!
March 8, 20179 yr 1 hour ago, HellDiverUK said: Folks, I have a Samsung PM851 SAMSUNG_MZNTE256HMHP which reports "Airflow temp" under SMART attribute 190, rather than the normal attribute 194 that's used on my HDDs. Is it possible to get some way of changing which attribute is used to report temp? Thanks! Are you referring to the temperature display in the main page?
March 8, 20179 yr Author 3 hours ago, bonienl said: Are you referring to the temperature display in the main page? Indeed, yes. Those Samsung drives can run toasty, so I'd like to keep an eye on the temps. Currently it just has a * - assuming the front page is using 194 and not picking up 190? The same issue applies to my ADATA SX8000 NVMe SSD, it uses a different SMART number (don't remember which, sorry!).
March 12, 20179 yr Author I don't know what happened, but it's now reporting the temp on the front screen. I didn't change anything, but it just started working yesterday.
March 12, 20179 yr While I haven't seen the code involved, it would surprise me if both 190 and 194 were not checked, probably have been for a long time, as both have commonly been used by different manufacturers for quite awhile. I suspect this was another case of out of sync spin state (drive spun up but emhttp not informed). If unRAID doesn't know a drive has been spun up, it won't show a temp. Edited March 12, 20179 yr by RobJ add phrase
March 12, 20179 yr Yes, both attribute 190 and 194 are checked to find the temperature value. Very likely the explanation of RobJ is causing the temperature to be displayed as '*'. What value is set for "Tunable (poll_attributes)" (see Disk settings)?
March 17, 20179 yr Author On 12/03/2017 at 5:00 PM, bonienl said: Yes, both attribute 190 and 194 are checked to find the temperature value. Very likely the explanation of RobJ is causing the temperature to be displayed as '*'. What value is set for "Tunable (poll_attributes)" (see Disk settings)? Poll_attributes is set at 1800. The temp is being read OK now from the Samsung. The ADATA's temp never worked, though who knows what weirdness is going on with that drive.
March 18, 20179 yr 4 hours ago, HellDiverUK said: Poll_attributes is set at 1800. I recommend changing that to either 60, 120, or 180 (1, 2, or 3 minutes).
Archived
This topic is now archived and is closed to further replies.