yahooo Posted February 23, 2020 Share Posted February 23, 2020 Hi, I have just installed the Binhex Prelear docker and right aftre the install my GUI looks like this (see attached snapshot) when I access it from the browser. I have unstiall the docker, rebooted several times but the UI still looks like innthe snapshot. Is there any way to repair this problem or do I need to reinstall unraid on my usb drive? Quote Link to comment
yahooo Posted February 23, 2020 Author Share Posted February 23, 2020 tried reinstalling unraid on the sub stick. Th bad GUI interface error has gone away but now i'm not able to mount my drive since i'm getting this error Quote Link to comment
Squid Posted February 23, 2020 Share Posted February 23, 2020 You had disk one assigned as ...7JW You've now assigned ...V3N as disk one. The error is correct and proper Do you have multiple drives? Do you know what was assigned where? Quote Link to comment
yahooo Posted February 24, 2020 Author Share Posted February 24, 2020 Yes, there are 2 drives in the build. drive 1: 7JW ( the correct drive to be mounted as disk 1) drive 2: V3N ( new drive added, that was not mounted previously in the arry nor used) The issue was finally resolved by selecting 7JW as disk2 in the array. Start the array -> Stop the array -> selecting it as disk 1 ( this time it worked) back again -> Start the array. So far everything seems to be working normally, hope that I didn't damaged anaything by doing the above workaround. V3N was installed yesterday in the build to be used as a parity disk but it's formated in NTFS and it has some WD programs on it so i wanted to install the preclear app to clean it and stress test it. After installing the preclear docker all of this happened. Not sure how to proceed next since I still need to use the disk as parity but don't want to install the preclear app and thorugh all this again. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.