StandardToast Posted April 26, 2020 Share Posted April 26, 2020 Hey everyone. I recently set up unraid about a week ago and everything was going fine. I upgraded my drives recently starting with my parity of 2tb to 8tb. I followed the guide on the Wiki and no problem there system was up and functional. After that I needed to upgrade my data drive. In this case I removed a 2tb drive again and upgraded to a 8tb drive. At some point during that the build failed and it ran a read check on that brand new 8tb drive (Shucked WD Easystore White label). Read check passed however the drive still shows disabled and I cannot enable it. I get a CRC Error and I have replaced the sata cable and it also happens on my SSD cache. This SSD is only 1 year old and shouldn't have this error either and if it matters I added the cahce and the 2nd 8tb drive (the data one) at the same time. Do I have a bad sata controller on my MB? Can I re enable this drive? Is there a Sata HBA someone could recommend? Thanks System Info M/B: Supermicro X8DAH Version 1234567890 - s/n: VM21S56452 BIOS: American Megatrends Inc. Version 2.1. Dated: 12/30/2011 CPU: Intel® Xeon® CPU X5687 @ 3.60GHz HVM: Enabled IOMMU: Enabled Cache: 256 KiB, 1024 KiB, 12288 KiB, 256 KiB, 1024 KiB, 12288 KiB Memory: 32 GiB Other Multi-bit ECC (max. installable capacity 192 GiB) WD Drive Error 199UDMA CRC error count0x000a200200000Old ageAlwaysNever6 SSD Cache Error 199SATA CRC error count0x0032100100000Old ageAlwaysNever1 tower-diagnostics-20200426-1539.zip Quote Link to comment
trurl Posted April 26, 2020 Share Posted April 26, 2020 Check all connections, power and SATA, both ends, including any power splitters. Disk looks fine so you can rebuild it to itself if you want. Do you know how? Quote Link to comment
StandardToast Posted April 26, 2020 Author Share Posted April 26, 2020 I have checked all cables again and confirmed should be no issues there. I still see the drive as "Device Disabled Contents Enumerated" and only have the option to start the array or start it in maintenance mode. Once I start it I do have the option to do a read check on all devices. what step should take next? Quote Link to comment
itimpi Posted April 26, 2020 Share Posted April 26, 2020 The steps to rebuild a drive are covered here in the online documentation. It has a specific mention of how to rebuild a disk onto itself if it has been disabled but you decide the drive is actually OK. Quote Link to comment
StandardToast Posted April 26, 2020 Author Share Posted April 26, 2020 Thanks parity rebuild is running now. Hopefully this should be the end of this Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.