shrekfx

Quick question on where to start to look for an answer, if it's possible, and how complicated it would be if it is. I have my Unraid Server set up on a 1u server. I will be installing a raspberry pi with octopi and have that connected to my 3d printer. Is there a way to use nginx on my server to point to the local IP of Octoprint for remote access to it? (if it is possible to do so that is). I tried the Octoprint docker and had it working on my printer, but have had 2 fails prints because the docker locked up or crashed. From some more research, most are saying to not use your server and have a dedicated pi for the printer. Anyways, direction would be great.

Can't find this anywhere, but is there a way to get an e-mail alert or something indicating that a peer lost connection or hasn't connected in x minutes/hours/days or whatever?

O.k. good to know Thanks.

Wondering if there will cause an issue physically moving hard drives around in my array? So I'm looking at organizing where my drives are in my case and will need to move some around. Is there an issue doing this? Or will be fine as long as they are in the same spot in the disk list?

No, I meant wiregaurd. I also use wire shark but I’m talking about my vpn connection to my server via wiregaurd. That works fine and can connect out to the internet. But can’t get out to the internet using tailspin. Sent from my iPhone using Tapatalk

I enabled it and still can’t connect out. Disabled tailspin and went back to wiregaurd and that is working fine. *shrug* Sent from my iPhone using Tapatalk

Hmmm. Not sure. I’ll take a look Sent from my iPhone using Tapatalk

O.k. found it.. Should have known it was there. Looks like it's on my ssd already that i use for cache so that will work.

Question regarding the setup. Reading the instructions, the /ps/tmp location. If I have the /ps/ location for the general files on my array, how do i map the /ps/tmp to a ssd cache drive?

I'm possibly looking at on having my old imac to the transcoding of some media files from my server. Was wonder if there is a good way or optimal way to have this connected to maximize transfer speeds between the mac and the server? Im guessing if select the file from handbrake on my make when the file is on the server, it has to move the file from the server to my mac, transcode it and then put it back on the server? I tried to use handbrake on my server and it was eating way to much resources.

Sorry. I meant elaborate. And you did thanks. Sent from my iPhone using Tapatalk

?? Can you alternate? Sent from my iPhone using Tapatalk

Nice. I’ll have to give it a try. After I’m don’t moving files around. Sent from my iPhone using Tapatalk

Nice. So the viewing of this, is it by folder/file name or by images only? Sent from my iPhone using Tapatalk

How is this for photo storage? Looking at possibly using this vs nextcloud maybe?? Wife is a photographer and have a good number of images...