adde r2

Hello, Is it intended behavior that you can change active-backup while array is running? I wanted to remove the active-backup from using multiple interfaces because Unifi was complaining that multiple interfaces was using the same IP, which was causing other issues. The active backup was set to 4 interfaces: eth1, eth2, eth3, and eth4 I had 4 VLANs on this interface too. Unraid 6.12.13 I went in while it was still running and unchecked eth2, eth3 and eth4 then pressed apply. This caused a breakup of the active backup, setting ALL interfaces of the backup (including the eth1) to inactive, deleted all VLANs (because it got set to disabled?) and somehow set the eth1 description to the last VLANs name. I had another unraid system with a similar setup (including VLANs) that I was going to update the same and when I did, the exact same happened. I set it to minor, but depending on how much configuration is deleted, it might be more serious for someone else. Let me know if you wanna know anything more. EDIT: After enabling the network again and re-entering the VLANs again, all shims and VLANs show up in the network tab (and under Interface Extras). They also show up under in the docker settings where they are enabled. But for some reason br1 and the first 3 VLANs don't show up when editing a docker, only the last VLAN show up. This did not happen on the other system, it worked fine after enabling the network. But the diagnostics is on the system where this happened, so might give some clues. EDIT 2: Nuking docker folder fixed the problems of them not showing. Best Regards, Adam diagnostics-20241022-0738.zip