jpurdy647

I also enabled the syslog server by adding that IP which did work but I don't think that should have affected any crashes

Oddly enough I have had 13 days of uptime so far, the only change this time is I have abstained from any updates to docker images. I'm going to let it go another week and if no issues try updates again.

Ahh! That makes sense! I will reseat the cable and if that increases further / again i'll replace it. Much thanks!

My drive says it is pre-fail in some attributes although it is a year old with minimal usage, my file server mostly archives, not a lot of in and out going on. Wondering how big a deal this is since I got a good hard drive and was hoping for longevity. Also the Newer WD Red drive seems to be fairing worse than my much older WD Blue drive at 1 and 2 years old respectively. Also I have a smart report saying thumbs down for the Red drive (which is parity) but I can't figure out what the actual error was that caused the thumbs down. Looking for some advice from some much more knowledgeable folk, thanks a ton! Here are my smart reports for both drives, let me know if I can provide better info jpurdy647server-smart-20231009-1852 (1).zip jpurdy647server-smart-20231009-1900.zip

I added the mirror to flash setting as enabled, hopefully that will work out next time it crashes, should be in a couple days or so.

Weird, I did previously enable syslog server but it doesn't write anything.

Hello, hoping to get some help figuring out what is causing my system to crash repeatedly. Help is much appreciated in advance! I just ran the system in safe mode for 3 days only to find it hung in safe mode as well, I hoped it was just a plugin issue but appears not. The system seems to run great for 2-7 days, then it will completely freeze and only an unclean forced shut down will get it running again. I have my diagnostic logs attached, I read somewhere there is also a setting that needs to be enabled for deeper logging, is this correct? I hope there is enough info in these logs but I can change settings if needed. I have the system running in safe mode again with minimal docker containers running, only my critical 3 for running my nextcloud instance, that needs to have a near 100% uptime so this has been very problematic. Especially since nextcloud itself is buggy enough already. Below are the containers running at this time, this last attempt in safe mode all but Dupe and Qdir were running jpurdy647server-diagnostics-20220611-2257 (1).zip feedback_diagnostics_1654555508 (1).zip

What is the web ui user / pass default? Also how is that configured?

I had to reinstall this docker, I lost my extra arguments indication the /dev/srX and /dev/sgX numbers for the drives. I know the numbers but am not getting the drives to be recognized in avidemux, can someone share a working parameter set with me? This is for some reason not in the documentation as far as I could find.