Botafoguense1965

Hello...can´t figure out what to put into the "destination" field to make Rclone copy files from my Dropbox (which shows ok) to a "dropbox" folder inside a share called " Nuvens" inside my Unraid...

Follow up: Connected via FTP and NFS using ForkLift…same speeds. Edited etc/nsmb.conf with “signing_required=no”, just the same…

Hello. Just built my first Unraid server, I'm just a regular guy, not an IT one, no experience with Linux, been around Macs for...ever. My network includes a MacBook running Ventura, where I have two ethernet adapters, one gigabyte connected to the router->internet provider, and the other, a 2.5gbe connected with a CAT5e cable direct to a secondary 2.5gbe ethernet card (eth1) in the Unraid server (the primary eth0 is a gigabyte connected to the router->internet provider). I set up the IP addresses so the 2.5gbes are in the 10.x.x.x range with a subnet mask of 255.255.0.0 (MacBook) and /16 (Unraid server). The gigabit ethernets are in the 196.x.x.x range with 255.255.255.0 subnet masks. Seems to work fine. I tested the LAN with an app (Lan Speed Test) and the 2.5 LAN is connecting at 1,83GB, which seems ok, since the drives in the array are regular hard drives, 54000rpm. Also have a 256gb NVME as cache pool. BUT...there´s alway a but... When I transfer a single large file, around 15gb, from the Mac to the array, it goes around 285mb/s. A folder with 11gb worth of music files, goes around 30 mb/s...with drops to 1mb/s...unberable... A searched the forum and found this post below that seems to present a solution, which I honestly did not understand...anyways I didn't do anything to my SMB settings, they are the default installation. Any hints? André calango-diagnostics-20230725-2028.zip

Hello all. I managed to make this app work after following the direction in this thread...very good. Now, is there a way to make it unidirectional, so I would only pull from Dropbox to my Unraid share to backup it, but not the way around? Best, André

Hello…did you get a solution fot this? I’m in your shoes… André

Hello all, just setting my first NAS with Unraid 6.12.2... As I understand, my data Shares, like "Photos" or "Movies" should be set like Cache for primary storage, Array for secondary and Cache->Array as mover action. Is that right? As to note my cache drive is a single 256gb NVME. But when I copy large sets of data between disks, like from an unassigned HD to an array HD (like when first loading the array) wouldn't it be better to use Array as the primary storage? Thanks for the help! Andre