ishtangli

Working without any issues. Wish we could update it to the latest though.

I downgraded the docker and tried to run an update. Getting an error PHP Warning: fopen(/data/updater.log): Failed to open stream: Permission denied in phar:///config/www/nextcloud/updater/updater.phar/lib/Updater.php on line 1128 Could not open updater.log

Got it to work. 1. Install DVB drivers plugin 2. Install Hyperion docker and add a new device /dev/video0

Did you install the DVB plugin to get /dev/video0 on the host?

Read up a bit more on this and I need to install a plugin for video0 to work. No video drivers I think. Anyhow, I'll probably wait for the "privileged" bug to be resolved before migrating my VM to docker.

I dont see a /dev/video0 on the host. Could it be because the grabber is being passed to a VM at the moment? I can see the device via USB bus though.

I got the docker and that's about it. Dont even know if I correctly passed the device and I cant recall the command I used.

Can you provide instructions? Im new to this.

Tried adding --device but that didn't work. I can see the device on the terminal but lsusb shows no devices.

How can I pass a USB Grabber to this docker?

Did you have wireguard before 6.10?

Read several posts with the same problem but no solution. I can't access anything other than unraid. On 6.9, I was able to access my router, VMs, Dockers. On 6.10, I'm limitted to unraid. Is there any new/special configuration?

Same exact problem. Have you found a solution?

I need help with wireguard. I've been trying to figure this out for weeks. I'm running 6.10rc5. I cant seem to get wireguard to allow access to my network. All i can connect to is unraid webgui. I used to be able to connect to my router and other dockers running on my server. I've tried remote tunnel, remote access to LAN, etc. None seem to work.

I'm really stumped and I need help troubleshooting. System was working fine for a week and then suddenly started locking up if there was 3d content. Setup: 10700k + Asus z490G GTX1080 Unraid 6.9.2 iGPU used by PLEX docker dGPU passed to VM with dumped vBios (hex edited) OVMF + i1440fx No changes made to Bios. No driver updated. Diagnostics attached. mynas-diagnostics-20210804-1331.zip Really hope someone can help me. Edit: whenever it locks up, it says "unable to power on device, stuck in D3." then the GPU fan ramps up to 100%. Is there a bios setting that I need to change to disable this?