knightrider15

did you ever figure this out? im in the same boat

thank you to everyone on this thread for your help and support, im learning so much here and am glad that theres a community to help me and not be rude

for some reason, it starts naming ethernet devices at 4, meaning i have eth4, eth5, eth6 but i still have settings for eth0

update, i rebooted the system into normal gui mode, and set the ip, gateway, and dns server manually, and now i can connect to the server online, but smb shares are not working

i am sorry that im not using the correct flags after ethtool, but im not sure what most of the help message means. but i booted in gui safe mode and it assigned itself an ip with the gateway set to kernel and after typing "ethtool" it says "bad command line argumets" but the help made no sense to me

Bcm95704ca40 is the model number of the two add in nics i intend to use

is anybody able to tell me why 0/7 network ports will detect a network cable? im very new to linux, and unraid, but ive tried different hardware configs, and its 7 different network ports, on three add in cards, and two onboard, across at least two different interfaces. it detects the hardware, but not the cables... tower-diagnostics-20171018-1242.zip

currently spinnup groups are disabled i just personally don't see why features should be removed

please keep spin up groups, this is a good way to avoid overloading a power supply and enables a smaller noise footprint

8 gb bacuase thats what i could afford

hello! im having some issues with my unraid install. im not sure what is wrong. I was attempting to pci-stub.ids=XXXX:XXXX my attemps were not working, so i deleted the string "pci-stub.ids=XXXX:XXXX" and rebooted. upon reboot, i found the flash xml or bottom file was blank. i also cannot start vm's or dockers. the aray boots up and works fine, but something is not correct. I would prefer to not erase everything as i do not have anywhere else to put all that data. attached is a w ord document with screenshots of the errors and problems i am facing. tower-diagnostics-20180129-1258.zip unraid issues.docx it appears that vms are actually enabled, as i can teamviewer into them, but have no vm's tab