xxbryantd

Ended up not being a cable or port issues. I delete the network.cfg file on the boot drive and then plugged in cables to all 3 ports to see if any would grab a new ip. I was then able to login and change my main eth0 back to my 10gb card and set my static ip that I wanted for server.

I swapped out my motherboard, cpu, and ram on my unraid server, now im unable to boot into gui. Iv tried servername.local and the direct ip, iv also tried to boot into safe mode with no luck. tower-diagnostics-20200221-0557.zip

Do you know a good tutorial I can use thats shows me how to use dos/uefi to erase it?

So I had to run the command as ./sas3flash and it ran with no problem, but now I get this message "ERROR: Cannot Flash IT Firmware over IR Firmware!" root@Tower:/lsi# ./sas3flash -o -f SAS9300_8i_IT.bin Avago Technologies SAS3 Flash Utility Version 17.00.00.00 (2018.04.02) Copyright 2008-2018 Avago Technologies. All rights reserved. Advanced Mode Set Adapter Selected is a Avago SAS: SAS3008(C0) Executing Operation: Flash Firmware Image Firmware Image has a Valid Checksum. Firmware Version 16.00.01.00 Firmware Image compatible with Controller. Valid NVDATA Image found. NVDATA Major Version 0e.01 Checking for a compatible NVData image... NVDATA Device ID and Chip Revision match verified. NVDATA Versions Compatible. Valid Initialization Image verified. Valid BootLoader Image verified. ERROR: Cannot Flash IT Firmware over IR Firmware! Firmware Image Validation Failed! Due to error remaining commands will not be executed. Unable to Process Commands. Exiting SAS3Flash.

I have a LSI 9300-8I PCI-Express 3.0 SATA card in my unraid server. I attempted to follow this below thread but not luck. When running sas3flash command I get no command found. What this best way to get this card into it mode from unraid?

I cant get the sas3flash command to work. I followed the instructions and use sas3flash -listall and I get bash: sas3flash: command not found

Disregard.

Didnt know this existed thanks

I have multiple sdr-dongles that are show up as RealtekCorp. RTL2838 DVB-T (0bda:2838) Im attempting to pass them through to the same virtual machine, but it will not allow me to start the vm? how do I fix this

Is there a way to get the real ip from visitors in my stats logs, instead of getting flooded with the cloudflare ips?

am i able to access NPM from a subdomain also? I cant seem to get it to work properly.

Is it possible to use the reverse proxy to point a subdomain to a different device on the local network? Swag is ran on unraid in a docker with the ip of 192.168.1.75. I want to point subdomain.url.com to 192.168.148:3000 but not sure how to do this?

Thanks, this was my issues. Thanks for your time.

How do I temporarily disable IPv6 to test and make sure this is my issue?

Sending it now