mavericksvvm Posted July 30, 2021 Share Posted July 30, 2021 1. My HDD enclosure went bad so none of my drives were showing up (Just a 4 disk USB 3.0 enclosure) 2. I am now running PCIe > SATA and all are recognized in BIOS and Unraid 3. The SN's have changed according to Unraid so I can't re-start my device 4. One of the drives may have actually gone bad during this time Any thoughts on why the Serial Numbers would have changed so Unraid doesn't think they are the correct drive, when in fact, they are the same physical drive. Quote Link to comment
JorgeB Posted July 31, 2021 Share Posted July 31, 2021 10 hours ago, mavericksvvm said: Any thoughts on why the Serial Numbers would have changed This is one of the reasons we don't recommend USB enclosures, they usually don't pass the correct serials, if parity is still valid there might be a way out, please post current diagnostics. Quote Link to comment
mavericksvvm Posted July 31, 2021 Author Share Posted July 31, 2021 Yep, that makes sense! So I did have one drive go bad during this, so I am just doing "New Config" which shockingly worked great! I can't see anything lost yet even though I removed that faulty drive, and it's rebuilding my parity now. Quote Link to comment
JorgeB Posted August 1, 2021 Share Posted August 1, 2021 16 hours ago, mavericksvvm said: I can't see anything lost yet even though I removed that faulty drive That's good, FYI there was a way to possibly also recover any data on the failed disk, but because you're rebuilding parity that's no longer possible. Quote Link to comment
trurl Posted August 1, 2021 Share Posted August 1, 2021 22 hours ago, mavericksvvm said: "New Config" which shockingly worked great! I can't see anything lost yet even though I removed that faulty drive, and it's rebuilding my parity now. Are you sure you assigned the correct disk to parity slot? Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.