acozad1 Posted September 11, 2021 Share Posted September 11, 2021 Hi All, Hope everyone is well. I wanted to see if I could get some help from all the pros on here. I cannot for the life of me assign my unraid to eth 0. I have stopped my array and there seem not to be a eth 0 to assign to. I have attached my files to this post in hopes that someone can point me in the right direction. So this board has 4 ethernet ports and I have added a SolarFlare 10gb sfp+ card that I want to use. It is connected and working but still says that eth 0 is down. Thank you for your help on time on this. supernova-diagnostics-20210911-1609.zip Quote Link to comment
JorgeB Posted September 12, 2021 Share Posted September 12, 2021 8 hours ago, acozad1 said: o this board has 4 ethernet ports and I have added a SolarFlare 10gb sfp+ There's also a Realtek NIC which is currently eth0, you can boot using the GUI mode and change that on Settings -> Network Settings -> Interface Rules (Reboot required) Quote Link to comment
acozad1 Posted September 13, 2021 Author Share Posted September 13, 2021 (edited) Hi Everyone, Thank you for the reply. Update: But my issue was that in the network settings I did not have a eth0 at the bottom. It started with eth1. So I have to edit the network rules on the usb flash drive and set the eth0 on my pci card (SolarFlare sfp+ card) by looking in devices setting and also the mac address. I now have it set to eth0 and I am able to set everything like I should have. Thank you for taking a look at this post and all the help and suggests. I really appreciate everyone in this forum. Edited September 13, 2021 by acozad1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.