RichJacot Posted October 19, 2021 Share Posted October 19, 2021 (edited) I've been replacing some 3-4TB drives with 14TB drives and now I'm having a problem. Everything was fine until early yesterday morning. I've done two other drives without an issue. Early yesterday I swapped in the third drive and parity was building. Later in the morning I noticed the system was down. I couldn't not get in via ssh nor the web gui. I tried pinging it and it wasn't responding. I went to the console and there were errors similar to the attached image (I didn't get a picture of the initial errors so I'm not sure they're identical or not). I let it sit for several hours and there was no change. I tried a shutdown, it didn't work but I let it sit for another hour or so, nothing. I tried a reboot and still nothing. I finally had to kill the power and boot it back up. It appeared to come up fine, I checked free space on all of the drives (including USB) and they were all fine. I started the rebuild again. Shortly there after it went down/froze again but this time I could shutdown from the command line on the console. After several reboots and trying different things... it appears to stay up on the network for a few minutes and then drops off and the attached image is on the console. Any ideas what might be causing this? (EDIT) Oh ya, I have tried using a different 14TB drive. The result is the same. Also, I brought it back up and just left it sit. I did not start the parity check or any other items. It still dropped off the network after 10 or so minutes. No errors on the console, it's still sitting at the login. TIA syslog Edited October 19, 2021 by RichJacot Added some info. I was able to pull my syslog before it went back down. Quote Link to comment
JorgeB Posted October 20, 2021 Share Posted October 20, 2021 Check filesystem on disk3. Quote Link to comment
RichJacot Posted October 20, 2021 Author Share Posted October 20, 2021 Disk 3 is the new one and was precleared without issue. I'm trying to run a check on all of the disks but it only stays up long enough to get about two checked. I'm about ready to flatten and start over. If I didn't have 12 or so dockers I've been fitz'n with for over a month, I'd have done that already... I'll let you know how I make out. Quote Link to comment
JorgeB Posted October 21, 2021 Share Posted October 21, 2021 11 hours ago, RichJacot said: but it only stays up long enough to get about two checked If it's still crashing in maintenance mode then there are other issues, and filesystem corruption is a result of the crashing, not the reason. Quote Link to comment
RichJacot Posted October 23, 2021 Author Share Posted October 23, 2021 You are/were right. I had a weird network issue. Now I'm working the filesystem issues it/I caused. Thank you for the help! Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.