Help Array : Device is disabled, Contents emulated AND udma crc error count

[JamesAdams]

Hi,

 

I just added new disks to my server, via a sata card ASM1166

And i have a lot of error : udma crc error count 

 

 

Now on one disque i have this message : DEVICE IS DISABLED, CONTENTS EMULATED.

So, i have follow this method

 

And now my parity are rebuild :

 

 

And during parity I continue to have the same error message more this one

 

What do you think I should do?

 

For information I have a sas card (Sas9211-8i) that I can use instead of the sata card (I guess the problem comes from the sata card)

 

Thanks for the help!

 

Edited April 22, 2022 by JamesAdams

[JamesAdams]

Is there a risk of data loss, if I stop the server during the rebuild of the array to replace the sata card by the sas card?

Edited April 22, 2022 by JamesAdams

[JorgeB]

Please post the diagnostics.

[JamesAdams]

2 minutes ago, JorgeB said:

Please post the diagnostics.

Yes, there here is

jamesserver-diagnostics-20220422-1016.zip

[JorgeB]

That controller uses SATA port multipliers, those are not recommended, you can cancel the rebuild, replace the controller then re-start rebuilding the disable disk.

[JamesAdams]

Just now, JorgeB said:

That controller uses SATA port multipliers, those are not recommended, you can cancel the rebuild, replace the controller then re-start rebuilding the disable disk.

Ok, so no worries canceling the rebuild and replacing the sata card with my sas card now, sure?

[JorgeB]

Yes, assuming it's a HBA, not a RAID controller.

[JamesAdams]

1 minute ago, JorgeB said:

Yes, assuming it's a HBA, not a RAID controller.

 

Normally his a HBA, https://www.ebay.com/itm/SAS9211-8i-SUN-Oracle-375-3640-02-SAS-8-port-HBA-PCI-e-Carte-NO-Bracket/403465591703?pageci=27d53a0a-32f3-4e7c-9049-766829cec21e&redirect=mobile

[JorgeB]

Depends on the flashed firmware, there's IT and RAID mode, though these usually still work even in RAID mode, but IT is still recommended.

[JamesAdams]

3 minutes ago, JorgeB said:

Depends on the flashed firmware, there's IT and RAID mode, though these usually still work even in RAID mode, but IT is still recommended.

There a tools on unraid for flash the card ?

[JamesAdams]

7 minutes ago, JamesAdams said:

There a tools on unraid for flash the card ?

I go test that