briansak Posted May 30, 2022 Share Posted May 30, 2022 After upgrading from 6.9.2 to 6.10.1 the system appears to make it through the boot procedure, resets, and boots again in an endless loop. I reimaged the USB to 6.9.2 and it boots to command prompt as expected. When on 6.10.X, I tried to boot into safe mode (with and without GUI) and experienced the same issue. My NAS consists of a FM2-A75IA-E53, A10-6700K and just two 8TB drives in RAID 1. Quote Link to comment
trurl Posted May 30, 2022 Share Posted May 30, 2022 Technically Unraid IS NOT RAID, but single parity with single data is effectively RAID1. How did you perform the upgrade? Quote Link to comment
briansak Posted May 30, 2022 Author Share Posted May 30, 2022 Yeah, not RAID just 2 drives, one being a parity drive. Sorry, didn't intend to cause confusion. The upgrade was completed directly from the interface Tools -> Upgrade OS. After I rebooted it went into the continuous reboot cycle. Quote Link to comment
trurl Posted May 31, 2022 Share Posted May 31, 2022 Do you have a backup of your flash drive? Quote Link to comment
briansak Posted May 31, 2022 Author Share Posted May 31, 2022 Yes, I've restored back to 6.9.2 and it's up and stable. Is there any logging I can do or capture if I try to upgrade to 6.10.X again? Quote Link to comment
JorgeB Posted May 31, 2022 Share Posted May 31, 2022 17 minutes ago, briansak said: Is there any logging I can do or capture if I try to upgrade to 6.10.X again? Enable the syslog server. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.