First time user, completely new build - SATA drives not showing up

[oro]

Hello,

 

I'm a first time user of Unraid, just setting up my first build with a trial license. I have the boot usb drive plugged into a header on the motherboard, I have a USB hard drive plugged into the motherboard externally, and an NVME drive that all show up and I was able to configure them in my array. I also have two drives connected over SATA (one sandisk SSD and one WD Red HDD) that do not show up in Unraid. They do however both. show up in the BIOS.

 

I searched online, and found suggestions to disable VT-d/IOMMU in the BIOS, which I tried, but that didn't fix the issue.

[oro]

Here is the diagnostics for my system

dachora-diagnostics-20220530-1346.zip

[JorgeB]

00:17.0 RAID bus controller [0104]: Intel Corporation Device [8086:43de] (rev 11)
    DeviceName: Onboard - Other
    Subsystem: ASUSTeK Computer Inc. Device [1043:8694]

 

No SATA controller being detected, only this, see if there's an option in the BIOS to change it to AHCI/SATA

[oro]

That was the issue! It was set to Intel QuickSync, I changed it to AHCI and both of the other drives showed up. Thanks!

Edited May 30, 2022 by oro
Hit send too early