kakmoster Posted November 19, 2022 Share Posted November 19, 2022 Four days ago unraid crashed and I started getting ATA3 errors during a parity check. I canceled the parity check as it was too slow. After that I did a simple check on my drives, just copying files to and from them without any issues. They all seemed fine and the errors stopped. However I checked the logs now and the errors persist. Diagnistics is attached. What is the issue, I can't figure it out. Thanks. blunova-diagnostics-20221119-2112.zip Quote Link to comment
Squid Posted November 19, 2022 Share Posted November 19, 2022 Those errors are indicative of a poor connection to the drive(s) either sata or power (SATA cabling is a very poor design). Reseat the cabling at both ends. ATA3 is WDC WD100EZAZ-11TDBA0 - disk 9 Take care not to disturb cabling adjacent to the ones you're reseating (or reseat them all) Quote Link to comment
kakmoster Posted November 19, 2022 Author Share Posted November 19, 2022 1 hour ago, Squid said: Those errors are indicative of a poor connection to the drive(s) either sata or power (SATA cabling is a very poor design). Reseat the cabling at both ends. ATA3 is WDC WD100EZAZ-11TDBA0 - disk 9 Take care not to disturb cabling adjacent to the ones you're reseating (or reseat them all) Thank you, I will look into that. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.