Moe Posted June 30, 2023 Share Posted June 30, 2023 Just a few days ago I went through an issue where a disk got disabled. I ran smart tests, everything looked okay so I rebuilt the data on to the same drive and all seemed fine. You can see the details of what happened here This morning I got a notification telling me that the same disk was disabled again. This time there are more errors and now I can't run a smart test on the drive. The problem drive is a 6TB drive and I have another drive in the array that is 12TB which is empty (although the webui shows that it's using 83.7 GB?). What I am thinking of doing is just removing the problem drive from the array and moving the data to the good 12TB drive. My question is, what is the best way of going about doing so? Should I use unBALANCE to move the files over? Is there a way to rebuild the data onto an existing drive? Is there something better I can do than these options? Any guidance would be greatly appreciated. I have also attached a diagnostic, I am curious if anyone can see why this drive keeps erroring out on me. Thank you. tower-diagnostics-20230630-0859.zip Quote Link to comment
JorgeB Posted June 30, 2023 Share Posted June 30, 2023 Disk6 dropped offline, power off, check/replace cables for that disk and post new diags after array start. Quote Link to comment
Moe Posted June 30, 2023 Author Share Posted June 30, 2023 Done. Cables seemed fine, I reseated them though. Ran a quick smart, it was fine. Diagnostic attached. Thank you. tower-diagnostics-20230630-1004.zip Quote Link to comment
JorgeB Posted June 30, 2023 Share Posted June 30, 2023 SMART looks fine, suggest replacing or swapping cables with another disk to rule that out then rebuild on top. Quote Link to comment
Moe Posted June 30, 2023 Author Share Posted June 30, 2023 Would you suggest swapping both data and power cables or just power? Quote Link to comment
Moe Posted June 30, 2023 Author Share Posted June 30, 2023 Thank you for your help again JorgeB, you're a gentleman and a scholar. Rebuild is started, should take about 24 hours and then it's finger crossing time. Thanks again. 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.