To_Be_Unraid Posted October 24, 2023 Share Posted October 24, 2023 (edited) Hello! My current setup is a simple 1 Data disk + 1 Parity disk (raid1 mirror special case). The Data disk failed (Diagnostics attached. The failure happened after main power went down twice in few hours, so unsafe shutdowns) Now I just want to use the Parity disk as the Data disk temporarily till I get a replacement. Since this's a special case (raid1 mirroring), it should be a simple procedure as far as I know. Any input is appreciated and thank you in advance! myserver-diagnostics-20231024-0616.zip Edited October 24, 2023 by To_Be_Unraid Diagnostics attached Quote Link to comment
trurl Posted October 24, 2023 Share Posted October 24, 2023 6 minutes ago, To_Be_Unraid said: The Data disk failed In what way? Attach Diagnostics to your NEXT post in this thread Quote Link to comment
dboonthego Posted October 24, 2023 Share Posted October 24, 2023 In your case, the parity disk is a mirror of the data disk. So depending on the nature of failure, your data may be secure on parity. Of course post the diagnostics and don't format anything! Quote Link to comment
To_Be_Unraid Posted October 24, 2023 Author Share Posted October 24, 2023 Attached the diagnostics in the original post. Thank you! Quote Link to comment
itimpi Posted October 24, 2023 Share Posted October 24, 2023 5 hours ago, To_Be_Unraid said: Now I just want to use the Parity disk as the Data disk temporarily till I get a replacement. Since this's a special case (raid1 mirroring), it should be a simple procedure as far as I know. In this special case you should not need to do anything as the parity disk is mirroring the data drive, so if the data drive is missing it will simply 'emulate' the missing disk1. When you get the replacement for disk1 you can then follow the standard process for rebuilding a failed drive. There is a significant chance that disk1 has not actually failed but was simply disabled due to a write failing caused by an external factor such as the SATA or Power cabling. However the drive is not showing up in the diagnostics - is it physically still in the machine? Quote Link to comment
dboonthego Posted October 24, 2023 Share Posted October 24, 2023 (edited) Was disk1 in a USB enclosure? When you get a replacement disk, you can simply install it and assign to slot1 to rebuild it from parity. In the meantime, you're effectively already using the parity as an emulated data disk. If your question is literally how to turn your parity disk into the data disk then you would Tools-->New config and assign the parity disk to disk1. This works in your scenario because you only have 1 data and 1 parity in raid1. There is no reason to do this unless you plan to use a replacement disk that is larger than your existing parity or if you just don't plan to replace the disk at all. Edited October 24, 2023 by dboonthego Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.