Lonewolf147 Posted December 4, 2023 Share Posted December 4, 2023 (edited) I upgraded to 6.12.6 this morning from 6.12.4. When I rebooted, 8 of my drives showed missing. I tried rebooting again, but no luck. I've attached my diagnostics from just after the upgrade. I have downgraded back to 6.12.4 to try and get my system running again. EDIT - Downgrading didn't work. Upon reboot the drives were still missing. valaskjalf-diagnostics-20231204-0712.zip Edited December 4, 2023 by Lonewolf147 Quote Link to comment
itimpi Posted December 4, 2023 Share Posted December 4, 2023 He disks are not being seen at the SMART level in the diagnostics. is there anything the disk having the problem share? If so that may well be the cause of the issue. Quote Link to comment
trurl Posted December 4, 2023 Share Posted December 4, 2023 Looks like power or controller problem. Are these disks on the same controller? Any power splitters? Quote Link to comment
Lonewolf147 Posted December 4, 2023 Author Share Posted December 4, 2023 I'm just starting to dig around in the case. I think they may all be on my HBA. I can't verify until I check the serial numbers against the list. But, if that is the problem, then could the update have messed with the HBA drivers? I'm concerned that they didn't come back online when I downgraded, if it is a drivers issue. Quote Link to comment
itimpi Posted December 4, 2023 Share Posted December 4, 2023 No - if downgrading does not fix it then it is almost certainly a hardware issue. If you think all the drives are on the HBA check it is properly seated in the motherboard, and no cabling to it has come loose. Quote Link to comment
Solution Lonewolf147 Posted December 4, 2023 Author Solution Share Posted December 4, 2023 (edited) Alright, so I'm back up and running now. I don't know why exactly. I shut everything down so I could pull each drive and mark it's location on my spreadsheet. I checked the HBA, it and its cables seemed fine. I went back to my list of 'missing' drives. None of them were on the HBA. All 8 drives were in one external USB enclosure. I'm guessing that when I powered down the enclosure to get at the drive serial numbers, it reset something in it, and let unRaid see them all again. I successfully upgraded back to 6.12.6. Edited December 4, 2023 by Lonewolf147 Quote Link to comment
trurl Posted December 5, 2023 Share Posted December 5, 2023 On 12/4/2023 at 10:50 AM, Lonewolf147 said: All 8 drives were in one external USB enclosure. USB not recommended for array or pools for many reasons. Don't be surprised if you have additional problems in future because of this. Quote Link to comment
Lonewolf147 Posted December 5, 2023 Author Share Posted December 5, 2023 2 minutes ago, trurl said: USB not recommended for array or pools for many reasons. Don't be surprised if you have additional problems in future because of this. Yeah. I know. It's my current only way of getting the extra drives into the array. I've been running this for over a year now and never had that specific problem. I get that it is risky, and I'm willing to accept that. In the meantime, I'm slowly saving money to get a larger case and a few more HBA's in order to move all the drives to an internal configuration. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.